Moxa IOLOGIK E2212 Manual de usuario Pagina 97

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 106
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 96
Click&Go User’s Manual Examples and Applications
4-29
Click&Go Programming Example
I/O Alias and Mode Configuration
1. Configure the 1
st
input channel to Event Counter mode, and Power On Settings toSTART”.
Configure the alias to Meter#1.
2. Configure the 1
st
digital output’s alias to PWR_Switch#1
Programming Manners
1. Turn on the power switch remotely and start recording the counts.
2. Turn off the power switch remotely and stop recording the counts. Report the readings and reset
the counter.
Click&Go Rule-set
NOTE
Internal Register-0 in this case is used to control the power switch attached to the digital output
channel. The control is done outside the ioLogik when running Click&Go logic. Refer to the
appendix for the Modbus/TCP Address table of the internal registers.
Vista de pagina 96
1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 105 106

Comentarios a estos manuales

Sin comentarios