Moxa IOLOGIK E2212 Manual de usuario descargar pdf (Pagina 64)

Click&Go User’s Manual Click&Go V2 Developing Process

3-44

NOTE

Only DI channels that are set to DI mode can mirror remote DO channels. Event Counter

channels cannot be used for peer-to-peer I/O operation. For analog input and output channels,

they must be configured to the same voltage or current mode. Also, a digital channel can not

mirror an analog output channel or vise versa.

Configuring Output Module

The peer-to-peer I/O output module is configured using one Click&Go rule for each DO channel

that is mirroring a remote input channel. In the Click&Go tab, start a new rule, select Enable

peer-to-peer I/O, and then select Output channel. Specify the output channel that will mirror the

remote input channel, the IP address of the input module, and the input channel on the input module

whose signals will be mirrored. The input module must have specified the output module’s IP

address as a destination IP.

When properly configured, the specified output channel will mirror the signals received by the

specified remote input channel, as if the channels were physically connected. For example, If the

remote DI channel’s status changes to “ON”, the specified DO channel’s status will change to “ON”.

If the remote DI channel’s status changes to “OFF”, the DO channel’s status will change to “OFF”.

Once both the input and output modules have been configured start peer-to-peer I/O operation by

activating the rule-set on both units and providing a valid network connection to each unit.

NOTE

Only DO channels that are set to DO mode can mirror remote DI channels. Pulse Output

channels cannot be used for peer-to-peer I/O operation. For analog input and output channels,

they must be configured to the same voltage or current mode. Also, a digital channel can not

mirror an analog output channel or vise versa.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 105 106

Sin comentarios

Moxa IOLOGIK E2212 Manual de usuario Pagina 64