Moxa IOLOGIK E2212 Manual de usuario descargar pdf (Pagina 63)

Click&Go User’s Manual Click&Go V2 Developing Process

3-43

The peer-to-peer I/O function is configured in two steps. On the input module, a Click&Go Logic

rule is defined to stream an input channel’s signals to one or more output modules. On the output

module, a Click&Go Logic rule is defined to receive an input module’s input channel signals and

mirror them on an output channel.

Configuring Input Module

The peer-to-peer I/O input module is configured using a single Click&Go rule. In the Click&Go tab,

start a new rule, select Enable peer-to-peer I/O, and then select Input channels mirror to. Click

Remote IP… and enter up to five IP addresses as destinations. Each IP address should belong to an

ioLogik unit that will act as an output module for peer-to-peer I/O operation. You can also set up

additional peer-to-peer I/O rules in order to mirror input channels to more than five destinations. If

all 24 rules are used for peer-to-peer I/O, a total of 120 destination IP addresses can be entered.

The ioLogik E2000 can simultaneously act as both an input module and an output module. Input

module operation would be configured in one rule, and another rule would be used to configure

output module operation.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 105 106

Sin comentarios

Moxa IOLOGIK E2212 Manual de usuario Pagina 63