
ioLogik Cellular Micro RTU Controller Getting Started
Connecting the Cellular Micro RTU Controllers over a Cellular
Network
When the environment is ready, follow these steps to test the ioLogik W5300 (refer to the figure below).
Step 1: Connect directly from the PC to the W5300 and use ioAdmin to configure the W5300’s cellular settings.
Step 2: For the ioLogik W5300, enter the user name, password, SIM Pin, APN, and define the Active OPC server
IP on the cellular settings page. Make sure the Operation Mode is correctly selected.
Step 3: Remove the cable connecting the PC and Controller, re-open ioAdmin, and then add Active OPC server
manually. The checkmarked PC will receive Internet access first.
Comentarios a estos manuales