
ioLogik Cellular Micro RTU Controller Click&Go Logic
Active Messages can be received by a program using standard sockets, Moxa MXIO library, or ioAdmin’s
Message Monitor, as shown in the following screen shot:
When sending a message in HEX, each HEX value must be separated by commas. View the incoming message
on the Message Monitor panel and select the HEX checkbox. Note that certain numbers are control characters
that will not show up in the Message Monitor. When sending a unicode message, the UCS2 checkbox must be
selected. View incoming messages on the Message Monitor panel and select the UCS2 checkbox. Note that
certain numbers are control characters that will not show up on the Message Monitor panel. The maximum
number of characters is 200.
Comentarios a estos manuales