Moxa IOLOGIK W5340-T Manual de usuario descargar pdf (Pagina 20)

ioLogik Cellular Micro RTU Controller Getting Started

2-4

Connecting to ioAdmin via Ethernet

Configuring the Computer’s IP Address

1. For initial configuration, we recommend using a direct connection through the RJ45 Ethernet

console port to a host computer, rather than remotely over the cellular network. Connect the ioLogik to

the host PC with an Ethernet cable.

2. Set the host PC’s IP address to 192.168.127.xxx. (where xxx can range from 001 to 253). In Windows,

you can adjust this setting through the Control Panel

Network and Internet. The default ioLogik

device settings are:

Default IP Address Default Netmask Default Gateway

192.168.127.254 255.255.255.0 None

Example IP: 192.168.127.200

Activating ioAdmin and connecting to the ioLogik

1. Open ioAdmin: Click Start  Program Files  MOXA  IO Server  Utility  ioAdmin.

2. Search the network for the ioLogik: When ioAdmin is started, it will automatically run the auto search

program. You may also click System  Auto Scan ioLogik device on the menu bar. A dialog window will

appear. Click Start Search to begin searching for your unit. Once the ioLogik has been detected, modify

the settings as needed for your network environment, and then restart the device.

NOTE

The

best approach to setting up a previously configured ioLogik is to first reset it to the factory default

using

the reset button

(see Chapter 1 for details). You can then use ioAdmin to configure the ioLogik.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 195 196

Sin comentarios

Moxa IOLOGIK W5340-T Manual de usuario Pagina 20