
ioLogik Cellular Micro RTU Controller Getting Started
DIN Rail / Wall Mounting
The ioLogik W5300’s built-in mounting appendages are suitable for mounting on a flat wall or installing on a
DIN rail. Follow the instructions in the figures below to install the W5300 on a DIN rail.
STEP 1: Insert the top of the DIN rail into the slot.
STEP 2: The DIN rail attachment unit will snap into place as shown below.
To remove the ioLogik W5300 from the DIN rail, insert a flat-blade screw driver horizontally into the DIN rail kit
under the ioLogik, and then pry it upwards to release the ioLogik W5300 towards and you away from the DIN
rail.
Comentarios a estos manuales