Moxa NPORT 5110-T Manual de usuario descargar pdf (Pagina 44)

NPort 5100 Series Web Console Configuration

5-21

0 min: TCP connection is not closed due to an idle TCP connection.

1 to 99 min: The NPort 5100 closes the TCP connection automatically if there is no TCP activity for the given

time.

Destination IP address

Setting Factory Default Necessity

IP address or Domain

Name

(E.g., 192.168.1.1)

blank Optional

TCP port No. 4001 Required

The Pair Connection “Master” will contact the network host that has this IP address. Data will be transmitted

through the port No. (4001 by default). Note that you must configure the same TCP port No. for the device

server acting as the Pair Connection “Slave.”

Pair Connection Slave Mode

When using Pair Connection Mode, you must select Pair Connection Slave Mode for the Operation mode of

one of the NPort 5100 device servers. In effect, this NPort 5100 will be acting as a TCP server.

TCP alive check time

Setting Factory Default Necessity

0 to 99 min 7 min Required

0 min: TCP connection is not closed due to an idle TCP connection.

1 to 99 min: The NPort 5100 closes the TCP connection automatically if there is no TCP activity for the given

time.

Local TCP port

Setting Factory Default Necessity

TCP port No. (e.g.,

4001)

4001 Required

This Port No. must be the same port No. that you set up for the Pair Connection “Master” device server.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 93 94

Sin comentarios

Moxa NPORT 5110-T Manual de usuario Pagina 44