Moxa NPORT 5110-T Manual de usuario descargar pdf (Pagina 27)

NPort 5100 Series Web Console Configuration

5-4

Web/Telnet Console

The “Disable” option for “Web Console” and “Telnet Console” is included for security reasons. In some cases,

you may want to disable one or both of these console utilities as an extra precaution to prevent unauthorized

users from accessing your NPort 5100. The factory default for both Web console and Telnet console is Enable.

Web console

Setting Factory Default Necessity

Enable or Disable Enable Required

Telnet console

Setting Factory Default Necessity

Enable or Disable Enable Required

ATTENTION

If you disable both the “Web console” and “Telnet console,” you can still use NPort Administrator to configure

NPort 5100 device servers either locally or remotely over the network. Refer to Chapter 6 for more detai

ls.

Reset button protect

Setting Factory Default Necessity

No or Yes None Optional

NOTE: Select the Yes option to allow limited use of the Reset Button. In this case, the Reset Button can be used

for only 60 seconds. I.e., 60 sec. after booting up, the Reset Button will be disabled automatically.

Network Settings

You must assign a valid IP address to the NPort 5100 before it will work in your network environment. Your

network system administrator should provide you with an IP address and related settings for your network. The

IP address must be unique within the network (otherwise, the NPort 5100 will not have a valid connection to the

network). First time users can refer to Chapter 3, Initial IP Address Configuration, for more information.

You can choose from four possible IP Configuration modes—Static, DHCP, DHCP/BOOTP, and BOOTP—

located under the web console screen’s IP configuration drop-down box.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 93 94

Sin comentarios

Moxa NPORT 5110-T Manual de usuario Pagina 27