Moxa NPORT 5110-T Manual de usuario descargar pdf (Pagina 28)

NPort 5100 Series Web Console Configuration

5-5

IP configuration

Method Function Definition

Static User defined IP address, Netmask, Gateway.

DHCP DHCP Server assigned IP address, Netmask, Gateway, DNS, and Time Server

DHCP/BOOTP DHCP Server assigned IP address, Netmask, Gateway, DNS, and Time Server, or

BOOTP Server assigned IP address (if the DHCP Server does not respond)

BOOTP BOOTP Server assigns IP address

IP address

Setting Factory Default Necessity

E.g., 192.168.1.1 (IP

addresses of the form

x.x.x.0 and x.x.x.255

are invalid.)

192.168.127.254 Required

An IP address is a number assigned to a network device (such as a computer) as a permanent address on the

network. Computers use the IP address to identify and talk to each other over the network. Choose a proper IP

address which is unique and valid in your network environment.

Netmask

Setting Factory Default Necessity

E.g., 255.255.255.0 255.255.255.0 Required

A subnet mask represents all of the network hosts at one geographic location, in one building, or on the same

local area network. When a packet is sent out over the network, the NPort 5100 will use the subnet mask to

check whether the desired TCP/IP host specified in the packet is on the local network segment. If the address

is on the same network segment as the NPort 5100, a connection is established directly from the NPort 5100.

Otherwise, the connection is established through the given default gateway.

Gateway

Setting Factory Default Necessity

E.g., 192.168.1.1 None Optional

A gateway is a network gateway that acts as an entrance to another network. Usually, the computers that

control traffic within the network or at the local Internet service provider are gateway nodes. NPort 5100 needs

to know the IP address of the default gateway computer in order to communicate with the hosts outside the

local network environment. For correct gateway IP address information, consult the network administrator.

IP configuration

Setting Factory Default Necessity

Static, DHCP,

DHCP/BOOTP, BOOTP

Static Required

ATTENTION

In Dynamic IP environments,

the firmware will retry 3 times every 30 seconds until network settings are

assigned by the DHCP or BOOTP server. The Timeout for each try increases from 1 second, to 3 seconds, to 5

seconds.

If the DHCP/BOOTP Server is un

available, the firmware will use the default IP address (192.168.127.254),

etmask, and Gateway for IP settings.

DNS server 1 / DNS server 2

Setting Factory Default Necessity

E.g., 192.168.1.1

(IP addresses of the

form x.x.x.0 and

x.x.x.255 are invalid.)

None Optional

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 93 94

Comentarios a estos manuales

Sin comentarios

Moxa NPORT 5110-T Manual de usuario Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores De Serie Moxa NPORT 5110-T