Moxa NPORT 5110-T Manual de usuario descargar pdf (Pagina 31)

NPort 5100 Series Web Console Configuration

5-8

Serial Parameters

ATTENTION

Check the serial communication parameters in your Serial Device’s user’s manual. You should set up NPort

5100’s serial parameters with the same communication parameters used by your serial devices.

Baudrate

Setting Factory Default Necessity

110 bps to 230.4 Kbps

(NPort 5110)

110 bps to 921.6 Kbps

(NPort 5150/5130)

115.2 Kbps Required

Data bits

Setting Factory Default Necessity

5, 6, 7, 8 8 Required

When the user sets Data bits to 5 bits, the Stop bits setting will automatically change to 1.5 bits.

Stop bits

Setting Factory Default Necessity

1, 1.5, 2 1 Required

Stop bits will be set to 1.5 when Data bits is set to 5 bits.

Parity

Setting Factory Default Necessity

None, Even, Odd,

Space, Mark

None Required

Flow control

Setting Factory Default Necessity

None, RTS/CTS,

DTR/DSR, Xon/Xoff

RTS/CTS Required

FIFO

Setting Factory Default Necessity

Enable, Disable Enable Required

NPort 5100’s serial ports provide a 16-byte FIFO both in the Tx and Rx directions. To prevent data loss during

communication, disable the FIFO setting when your serial device does not have a FIFO.

Interface

Setting Factory Default Necessity

RS-232/422/485 only RS-232/422/485 only Required

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 93 94

Sin comentarios

Moxa NPORT 5110-T Manual de usuario Pagina 31