Moxa VPORT 254-M-SC-T Manual de usuario descargar pdf (Pagina 79)

VPort 254 User’s Manual System Configuration

4-35

The configurations described below are only available in PTZ Driver mode.

Port Settings

Setting Description Default

Baud rate (bps)

The baud rate specified by the PTZ

camera’s serial communication specs.

2400

Data bits 8

Stop bits 1

Parity bits

The parameters used to define the serial

communication.

None

PTZ Camera Drivers

VPort products come with PTZ camera drivers for some of the popular PTZ cameras.

Administrators can select the correct PTZ driver in Select the camera driver menu. If the attached

PTZ camera is not supported by the VPort, administrators can use the Custom Camera function to

enter the proprietary commands for pan, tilt, zoom, and focus control.

Setting Description Default

Select the camera

driver

Use the built-in PTZ drivers, including

1. Custom Camera

2. Pelco D

3. Pelco P

4. Dynacolor DynaDome

Pelco D

Set Up Custom Commands

VPort products provide 10 custom commands in addition to the general pan, tilt, zoom, and preset

functions, which are also shown on the PTZ Control Panel . Administrators can click on Setup

Custom Commands to configure the commands, and refer to the manual enclosed with the

attached PTZ camera to set up frequently-used functions. The Command should be entered in

ASCII format. The VPort will translate the commands into binary code and then send the data out

through the serial port. For instance, the text string 81 01ABCDEF will be translated into five

bytes of hexadecimal: 81, 01, AB, CD, and EF. The maximum length of a command string is 60,

which is equivalent to 30 hexadecimal bytes. The Display string is for the text on the command

buttons and should be less than 8 characters. If Custom Camera is selected, there will be more

commands for PTZF that relate to custom camera.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 97 98

Sin comentarios

Moxa VPORT 254-M-SC-T Manual de usuario Pagina 79