Moxa AWK-1100 Manual de usuario descargar pdf (Pagina 23)

AirWorks AWK-1100 User’s Manual Web Console Configuration

To restore the configuration of the AWK-1100 by TFTP:

1. Prepare a computer that will be used as a TFTP server and as a managing computer to trigger

the restoring process.

2. Connect the computer and one of the LAN Ethernet switch ports with a normal Ethernet cable.

3. Configure the IP address of the computer so that the computer and the AWK-1100 are on the

same IP subnet.

4. On the computer, run the TFTP Server utility, and specify the folder in which the

configuration backup file resides. A configuration backup file is named with the AWK-1100’s

MAC address. For example, if the AWK-1100’s MAC address is 00-01-02-33-44-55, the

configuration backup file should be “000102334455.hex”.

5. On the computer, open the web browser and click the General, Firmware Tools hyperlink.

6. Choose TFTP as the Firmware management protocol.

7. In the Configuration Backup/Restore section, specify the IP address of the computer that

acts as a TFTP server. If you don’t know the IP address of the computer, open a Command

Prompt, type ipconfig, and then press the Enter key.

8. Trigger the restoring process by clicking Restore. The AWK-1100 will then download the

configuration backup file from the TFTP server.

NOTE

Make sure the file is a valid configuration backup file for the AWK-1100.

TIP

If you want to back up or restore the configuration from a remote location over the Internet,

adjust the Timeout and Max no. of retries settings of TFTP Server for remote TFTP

configuration backup/restore to succeed.

Resetting the Configuration to Factory Defaults

Clicking the Reset button resets the device configuration to factory defaults.

WARNING

Think twice before clicking the Reset button. Doing so will cause you to lose all of your current

configuration settings.

3-10

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Sin comentarios

Moxa AWK-1100 Manual de usuario Pagina 23