Moxa UC-7110 Manual de usuario descargar pdf (Pagina 13)

UC-7112 LX Plus UC-7112, UC-7110 User’s Manual Hardware Introduction

Internal SD Socket

The UC-7112 and UC-7112 Plus have an internal SD socket for storage expansion. For the

UC-7112, a Secure Digital (SD) memory card compliant with the SD 1.0 standard can be used to

provide up to 1 GB of additional memory space. In addition, the UC-7112 Plus supports Secure

Digital High Capacity (SDHC) memory cards that are compliant with the SD 2.0 standard, and can

be used to provide up to 16 GB of additional memory space.

To install an SD card, first remove the outer cover of the embedded computer to access the SD slot.

The internal SD slot is located on the back of the bottom board, in the slot on the right side of the

UC-7112 and UC-7112 Plus, but lower than the cover screw. Plug the SD card directly into the

socket and remember to “push in” the SD card first if you want to remove it.

Additional Functions

Reset Button

Press the “RESET” button continuously for more than 5 seconds to load the factory default

configuration. After loading the factory defaults, the system will reboot automatically. The System

Ready LED will blink for the first 5 seconds. We recommend that you only use this function if the

software is not working properly. To reset the µClinux system software, always use the software

reboot command (reboot) to protect the integrity of the data being transmitted. The reset button is

NOT designed to hard reboot the UC-71xx series embedded computer.

ATTENTION

For the UC-7110-LX and UC-7112-LX, resetting the embedded computer to factory defaults will

NOT cause the user directory to be reformatted, and the user's data will NOT be deleted. The reset

button only causes a configuration file to be loaded. All files in the /etc directory will revert to

their factory defaults, but all other user data will remain intact in the Flash ROM.

For the UC-7112-LX Plus, resetting the embedded computer to factory defaults WILL cause the

user directory to be reformatted; the files in the /home directory will be deleted, and all files in the

/etc directory will revert to their factory defaults, but all other user data will remain intact in the

Flash ROM.

Please note that if there is a problem with the /etc directory, the embedded computer may be

unable to restore the factory default settings.

ATTENTION

This function only takes effect when the user directory is working correctly. If the user directory

has crashed, the kernel will automatically load the factory defaults.

2-4

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

Moxa UC-7110 Manual de usuario Pagina 13