Moxa CP-138U-I-T Manual de usuario descargar pdf (Pagina 39)

Universal PCI Board User’s Manual Driver Installation: Windows Vista/2008

3-11

Configuring the Ports

After the board and serial port drivers are installed, the board’s Properties window will appear. The

system will map the ports automatically. You may be prompted to take care of port configuration if

other Moxa boards have been installed.

1. On the Ports Configuration tab, select a port to configure and click Port Setting.

Under Port Number, select a COM number to assign to the serial port. Select Auto

Enumerating COM Number to map subsequent ports in numerical order. For example, if

COM 3 is assigned to Port 1, then COM 4 will be automatically assigned to Port 2.

Select an Rx FIFO Trigger and Tx FIFO Size. The default Rx FIFO Trigger is 120 bytes (high

level). The default Tx FIFO Size is 128 bytes (high level). Select Set the change to all ports to

use this setting for all serial ports on the board.

Tx FIFO Rx FIFO

High

128 120

Middle

64 60

Low

1 1

Click OK to approve the settings for the selected port. Continue in the same way to configure

the other ports. When you have finished setting up the ports, click OK to close the Properties

window and apply the new port settings.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 140 141

Sin comentarios

Moxa CP-138U-I-T Manual de usuario Pagina 39